Formatting File System (Memory Area) - Mitsubishi Electric C70 Setup Manual

4.5 Formatting File System (Memory Area)

Memory in the CNC device (machining program, tool data area, etc.) must be formatted. Follow the following procedure.
The following contents will be erased by formatting.
- Machining program
- Tool data area (Tool length, tool wear data, etc.)
- Common variables (#100-#199, #500-#999)
(1) Turn the power ON again to enable the parameter settings.
(2) Select [TOOL PARAM] on the "CNC monitor" screen to display the [BASE SPEC. PARAM] screen (SETUP PARAM
1. 3/22).
(3) Set the parameter "#1060" to "1", then touch the "INPUT" key to startup the CNC setup (internal memory
formatting) function.
(4) When the message "BASE PARA. SET? (Y/N)" appears, touch the "N" and "INPUT" keys.
And when the message "FORMAT? (Y/N)" appears, touch the "Y" and "INPUT" keys.
(5) Turn the power OFF and ON.
(Note) The page number differs depending on NC's version. The explanation on this page is based on the one with
22 pages.
Press the button twice.
C70 Setup Manual
4.5 Formatting File System (Memory Area)
87