Mitsubishi Electric C70 Setup Manual page 619

MITSUBISHI CNC
Appendix 3 Display on 7-segment LED
(10) System warning
Alarm/warning code
Z30 ETHERNET ERROR 0006 0003
1L 1C 1R 2L 2C
Alarm type Alarm No.
Z53 TEMP. OVER 0003
1L 1C 1R 2L 2C
Alarm type Alarm No.
Z55 RIO NOT CONNECT 0007 0007
1L 1C 1R 2L 2C
Alarm type Control unit
Z59 TIME CONSTANT
1L 1C 1R 2L 2C
Alarm type Blank
Z20 Power ON again 1002
1L 1C 1R 2L 2C
Para No.
Alarm type
Up 2 digits
Z20 Power ON again 26701
1L 1C 1R 2L 2C
Para No.
Alarm type
Up 2 digits
Z20 Power ON again
1L 1C 1R 2L 2C
Alarm type Blank
(Note 1) The Nos. of parameters which are validated by turning the power ON again will be displayed divided into
upper and lower digits.
A 4-digit parameter No. will be divided into upper 2 digits and lower 2 digits.
A 5-digit parameter No. will be divided into upper 2 digits and lower 3 digits.
(Note 2) The alarm "Z20 Power ON again" will occur when inputting parameter data or SRAM.BIN data, but the
parameter No. will not be displayed. And the display on 7-segment LED will be blank.
602
1L 1C 1R
2R 3L 3C 3R
Communication
type
2R 3L 3C 3R
Blank
2R 3L 3C 3R
Board unit
2R 3L 3C 3R
Blank
2R 3L 3C 3R
Para No.
Low 2 digits
(Note 1)
2R 3L 3C 3R
Para No.
Low 3 digits
(Note 1)
2R 3L 3C 3R
Blank
(Note 2)
7-segment LED display (Transition)
2L 2C 2R 3L 3C 3R