Mitsubishi Electric C70 Setup Manual page 514

A01 MULTI CPU ERROR 2112
Details
- The module other than intelligent function module is specified by the intelligent function module/
special function module dedicated instruction. Or, it is not the corresponding intelligent function
module.
- There is no network No. specified by the network dedicated instruction. Or the relay target network
does not exist.
Remedy
- Read the individual information of the error using a programming tool and check the special function
module dedicated instruction (network instruction) that corresponds to the value (program error part)
to make modification.
A01 MULTI CPU ERROR 2116
Details
- An instruction that does not allow the module under the control of another CPU to be specified is
being used for a similar task.
Remedy
- Read the individual information of the error using a programming tool and check the special function
module dedicated instruction (network instruction) that corresponds to the value (program error part)
to make modification.
A01 MULTI CPU ERROR 2124
Details
- A module is installed to the 65th or higher slot.
- A module is installed to the slot whose number is greater than the number of slots specified in the
base setting.
- A module is installed to the location corresponding to the I/O points of the 4,096 or greater.
- A module is installed to the slot whose assigned I/O range includes the limit of.
Remedy
- Remove the module installed to the 65th or later slot.
- Remove the module installed at the slot whose number is greater than the number of slots specified
in the base setting.
- Remove the module installed to the location of I/O points, 4,096 or greater.
- Replace the last module to a module which does not exceed the 4,096th point.
A01 MULTI CPU ERROR 2125
Details
- A module which the QCPU cannot recognize has been installed.
- There was no response form the intelligent function module/special function module.
Remedy
- Install a usable module.
- The intelligent function module is experiencing a hardware fault. Contact your local service center.
A01 MULTI CPU ERROR 2140
Details
- Motion CPU (Q172LX, Q172EX (-S1, S2, S3) or Q173PX(-S1)) is mounted to the CPU slot or slot
No. 0 to 2.(QnUD(H)CPU does not lead this error.)
Remedy
- Remove the motion CPU that is mounted to the CPU slot or slot No. 0 to 2.
A01 MULTI CPU ERROR 2150
Details
- In a multiple CPU system, the control CPU of the intelligent function module incompatible with the
multiple CPU system is set to other than CPU No.1.
Remedy
- Change the intelligent function module for the one compatible with the multiple CPU system (function
version B or later).
- Change the setting of the control CPU of the intelligent function module incompatible with the
multiple CPU system to CPU No.1.
C70 Setup Manual
Appendix 2.11 Multi CPU Errors (A)
497