Stroke End (H/W Ot) - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
9 Setting the Tool Entry Prohibited Range
Stroke End (H/W OT) and Stored Stroke Limit (S/W OT) set the tool entry prohibited range and detect the overtravel
(OT).

9.1 Stroke End (H/W OT)

The axis movement is controlled by the limit switch which detects the stroke end.
Signal device No. is allocated by the following parameters.
Parameter "#2074" and "#2075" will be valid only when "#1226 aux10/bit" is set to "1".
#1226 aux10/bit5: Set to "1" (assigning the signal is valid).
#2074 H/W OT+: Set the input device for assinging the OT (+) signal. (Setting range 0000 to 02FF (Hexadecimal) )
#2075 H/W OT-: Set the input device for assinging the OT (-) signal. (Setting range 0000 to 02FF (Hexadecimal) )
(Note 1) When "OT IGNORED" (R2420) signal is set to ON, the stroke end signal associated with a specific control axis
can be ignored.
(Note 2) When parameter "#1226 aux10/bit5" is set to "1", do not set the same device No. to #2073 to #2075.
Setting the same device No. may cause the emergency stop. However, the device number will not be checked
for the axis which is set the signal to ignore (R2420, R2421).
144