Mitsubishi Electric C70 Setup Manual page 41

MITSUBISHI CNC
2 GOT Initial Setup
Items
Standard monitor OS
Communication
Driver
Extended function OS
Option OS
(Note) Note that "Ethernet connection" and "Bus/Network Group" are on the different trees in the communication
driver setting for GT16.
The following shows the "Extended function OS" and "Option OS". "CNC monitor", "CNC data input/output", and
"GOT platform library" must be selected. Select other functions as needed.
- Functions required to operate CNC
CNC monitor (Option OS)
This function is required for starting up the CNC, adjustment, or diagnosis when alarm occurs.
This enables the position display of axes controlled by CNC, alarm diagnosis, and machining program
editing.
CNC data input/output (Extended function OS)
This function enables to input and output machining programs or CNC parameters between the GOT
memory card (CF card or USB memory) and CNC.
Backup/ Restore (Extended function OS)
This function enables PLC/CNC CPU data backup and restoration. GT15 uses a CF card in the GOT rear
slot, and GT16 uses a CF card in the GOT rear slot or USB memory in the front slot.
- Functions required to operate PLC
CNC monitor (Option OS)
This function enables to display the sequence program of PLC CPU in ladder format.
The operating status of the sequence circuit can be checked.
Ladder editor (Option OS)
This function enables to monitor and edit the sequence circuit.
This allows operation check and modification of the sequence circuit without connecting to a personal
computer (GX Works2).
A CF card needs to be mounted on GOT.
System monitor (Extended function OS)
This function enables to monitor the state of device signal.
For details, refer to the <"GOT1000 series Extended function OS/Option OS Manual"> (SH(NA)-080541).
(5) The GOT automatically restarts after the installation is completed.
(Note) For details about standard functions (standard monitor OS), communication drive and BootOS installation,
refer to the "GT Designer3 Version1 Screen Design Manual (Fundamentals)" (SH(NA)-080866), Section 8.
24
For Ethernet connection
For GT15: "Ethernet(MELSEC), Q17nNC, CRnD-
700" under "Bus/Network Group"
For GT16: "Ethernet(MELSEC), Q17nNC, CRnD-
700" under "Ethernet Connection"
"System monitor", "Backup/Restore", "CNC data input/output", "GOT platform library" (This is
required for CNC data input/output. This is automatically selected when "CNC data input/output"
is selected. )
"Ladder monitor for MELSEC-Q/QnA" under "Ladder monitor", "Ladder editor", and "CNC monitor"
For bus connection
All
"Bus(Q)" under "Bus/Network Group"