Mitsubishi Electric C70 Setup Manual page 411

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#7714】 <check> Selection of area check method PSW22
When position switch area checking at high speed is selected, specify the mode of area checking,
i.e., whether to use the command type machine position or detector feedback position, for each
position switch point.
0: Use the command type machine position as the machine position for position switch area
1: Use the detector feedback position as the machine position for position switch area checking.
【#7721】 <axis> Axis name PSW23
Specify the name of the axis for which a position switch is provided.
---Setting range---
NC axis: axis name (X, Y, Z, U, V, W, A, B, or C)
【#7722】 <dog1> Imaginary dog position 1 PSW23
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X67E
Part system 2 device: X6FE
---Setting range---
-99999.999 to 99999.999 (0.001mm)
【#7723】 <dog2> Imaginary dog position 2 PSW23
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X67E
Part system 2 device: X6FE
---Setting range---
-99999.999 to 99999.999 (0.001mm)
【#7724】 <check> Selection of area check method PSW23
When position switch area checking at high speed is selected, specify the mode of area checking,
i.e., whether to use the command type machine position or detector feedback position, for each
position switch point.
0: Use the command type machine position as the machine position for position switch area
1: Use the detector feedback position as the machine position for position switch area checking.
【#7731】 <axis> Axis name PSW24
Specify the name of the axis for which a position switch is provided.
---Setting range---
NC axis: axis name (X, Y, Z, U, V, W, A, B, or C)
【#7732】 <dog1> Imaginary dog position 1 PSW24
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X67F
Part system 2 device: X6FF
---Setting range---
-99999.999 to 99999.999 (0.001mm)
【#7733】 <dog2> Imaginary dog position 2 PSW24
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X67F
Part system 2 device: X6FF
---Setting range---
-99999.999 to 99999.999 (0.001mm)
394
checking.
checking.