Mitsubishi Electric C70 Setup Manual page 221

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1226】 aux10
bit0: Tool compensation data for external workpiece coordinate offset measurement
Select the tool offset data to be used for external workpiece coordinate offset measurement.
0: Tool length data and nose wear data
1: Tool length data
bit1: Optional block skip type
Select whether to enable optional block skipping in the middle of a block.
0: Enable block skipping only at the beginning of a block.
1: Enable block skipping at the beginning of the block and in the middle of a block.
bit2: Single block stop timing
Select the timing at which the single block signal is enabled.
0: Enable the single block stop after the block is finished, when the signal goes ON during
1: Enable the single block stop when the signal is ON at the end of the block.
bit3 : C axis reference position return type
Select the type of reference position return for the C axis.
0 : Return to the zero point by G28 reference position return command and manual reference
1 : The reference position return will be carried out before executing the first block of the first C axis
bit4: S command during constant surface speed
Select whether to output a strobe signal when S command is issued in constant surface speed
mode.
0: Output no strobe signal in constant surface speed mode.
1: Output strobe signals even in constant surface speed mode.
bit5: Dog/OT signal arbitrary assignment enabled
Select whether to enable the signal assignment for the origin dog and H/W OT.
0: Disable
1: Enable arbitrary allocation
bit6: Setting and display unit selection
Select the unit to be used as the setting/display unit or handle feed unit from the command unit or
internal unit.
0: Internal unit
1: Command unit
(Note 1) This parameter is enabled only in initial millimeter mode (when "#1041 I_inch" is set to "0").
(Note 2) This parameter is enabled immediately after it is set.
(Note 3) If addition setting is performed for tool and workpiece offset data with the command unit
Related parameter: "#1152 I_G20 (Initial command unit)"
204
automatic operation startup.
position return start-up.
command after switching over to the C aix mode in an automatic mode. Return to the zero point
by G28 reference position return command and manual reference position return start-up.
The internal unit is always used in initial inch mode (when "#1041 I_inch" is set to "1").
"inch" and internal unit "mm", an error may occur.