Mitsubishi Electric C70 Setup Manual page 240

【#21101】 add01
bit0: FPLC axis rapid traverse mode acceleration/deceleration type
Select the acceleration/ deceleration type in PLC axis's rapid traverse mode.
0 : Select constant time-constant acceleration/deceleration
1 : Select constant inclination acceleration/deceleration
(Note) This parameter cannot be used when the peripheral axis (MC1K I/F) is used.
bit1: FPLC axis cutting feed mode acceleration/ deceleration type /Peripheral axis
(MC1K I/F) acceleration/ deceleration type
Select the acceleration/ deceleration type in PLC axis's cutting feed mode.
0 : Select constant time-constant acceleration/deceleration
1 : Select constant inclination acceleration/deceleration
(Note) Select the peripheral axis's (MC1K I/F) acceleration/deceleration type when the peripheral
bit2: FCircular command block overlap enabled
Select whether to enable the block overlap at the circular command.
0 : Disable
1 : Enable
bit3: FG31 automatic acceleration/ deceleration
Select whether to enable dry run, override and automatic acceleration/ deceleration for the G31
(skip) command.
0 : Disable
1 : Enable
bit4
Reserved for system.
bit5
Reserved for system.
bit6
Reserved for system.
【#21102】 add02
bit1
Reserved for system.
bit2
Reserved for system.
【#21103】 add03
bit0
Reserved for system.
bit1
Reserved for system.
axis is used.
Appendix 1.3 Base Specifications Parameters
C70 Setup Manual
223