Setting Nc Base Parameters; Setting Parameters To Specify The Machine's Basic Configuration - Mitsubishi Electric C70 Setup Manual

6.4 Setting NC Base Parameters

6.4.1 Setting Parameters to Specify the Machine's Basic Configuration

(1) On the [BASE SPEC. PARAM] screen, scroll to the following parameters to set each of them.
#1025 I_plane: Select the plane to be selected when the power is turned ON or reset.
0: X-Y plane (G17 command state)
1: X-Y plane (G17 command state)
2: Z-X plane (G18 command state)
3: Y-Z plane (G19 command state)
#1026-1028 base_I, J, K: Set the names of the basic axes that compose the plane.
Set the axis name set in "#1013 axname". Normally, when X, Y and Z are specified respectively for
base_l,_J,_K, the following relation will be established: G17: X-Y, G18: Z-X, G19: Y-Z.
#1029 aux_I: Set the axis name when there is an axis parallel to "#1026 base_I".
#1030 aux_J: Set the axis name when there is an axis parallel to "#1027 base_J".
#1031 aux_K: Set the axis name when there is an axis parallel to "#1028 base_K".
#1037 cmdtyp: Set the G code list and compensation type for programs.
G code list
List 1 (for M)
List 1 (for M)
List 2 (for L)
(Note)
#1038 plcsel: Set to "0".
#1041 I_inch: Select the unit system for the program travel amount when the power is turned ON or reset and for
position display. (0: Metric system, 1: Inch system)
#1042 pcinch: Select the unit system for the commands to the PLC axis. (0: Metric system, 1: Inch system)
#1043 lang: Select the display language. (0: English, 1: Japanese)
#1044 auxno: Set to "0".
Compensation type
Type A (one compensation amount for one compensation No.)
Type B (shape and wear compensation amounts for one
compensation No.)
Type C (shape and wear compensation amounts for one
compensation No.)
When "#1037 cmdtyp Command type" is changed, file system formatting is required. For
how to execute formatting, refer to "4.5 Formatting File System (Memory Area)".
C70 Setup Manual
6.4 Setting NC Base Parameters
109