Mitsubishi Electric C70 Setup Manual page 223

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1228】 aux12
bit0: Switch coordinate value screen
Set this to switch the coordinate value screens.
0: 80-character screen
1: 40-character screen
bit1: Switch "offset and parameter" screen
Select to switch the "offset and parameter" screen to the parameter screen.
0: Display the "offset and parameter" screen.
1: Display the "parameter" screen.
bit2: Switch data protection in data transmission mode
Select the data protection range in data transmission mode.
0: Enable the protection in both sending and receiving data.
1: Enable the protection only in sending data.
bit4: Select operation error or stop code
Select whether to handle the block start and cutting start interlocks as stop codes.
0: Operation error
1: Stop code
bit5: Select constant surface speed coordinates
Select the coordinate system for constant surface speed control.
0: Workpiece coordinate
1: Absolute value coordinate
bit6: Switch relative values displayed
Select whether to preset the relative coordinates with counter preset (G92).
0: Preset the relative coordinates.
1: Not preset the relative coordinates.
bit7: Protection with manual value command
Select whether to protect a manual value command.
0: Not protect. (Same as conventional)
1: Protect.
206