Mitsubishi Electric C70 Setup Manual page 112

(2) When setting the control signal of CPU#3 to G14000
Set "7" to the parameter "#26701 CPU specific send range(K)" for CPU#1. Set the parameter for CPU#3 in the
same manner as CPU#2.
Setting up the 1st CNC CPU (CPU#2)
MULTI CPU PARAM.
EMG EMERGENCY M01 OPERATION ERROR
Apply the same settings to the 2nd CNC CPU. However, set "14000" to the parameter "#26742 G Device TOP
number".
Setting up the 2nd CNC CPU (CPU#3)
MULTI CPU PARAM.
EMG EMERGENCY M01 OPERATION ERROR
DATA
BASE AXIS SERVO
DATA
BASE AXIS SERVO
5.5 Setting Multi-CPU Parameters to CNC CPU
SETUP PARAM
MULTI
MENU
SETUP PARAM
MULTI
MENU
C70 Setup Manual
95