Hardware And Device Configuration - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
1 Outline
This manual explains the procedures to setup C70.
Procedures when setting up again (with backup files of parameters and so on) are different from those of initial setup.
For initial setup, see the chapter of "Flow of the initial setup".
When setting up with the backup file, see the chapter of "Data Restoration".

1.1 Hardware and Device Configuration

Here are the names of the hardware used in this manual.
GT Designer3
GT Designer2
GX Works2
GX Developer
(Note 1) GT Designer2 Version 2.96A or later is required.
GT Designer3 Version 1.37P or later is required.
GX Developer Version 8.78G or later is required.
(Note 2) Ethernet communication with GOT1000 series GT15 requires the Ethernet communication unit (GT15-
J71E71-100).
(Note 3) Q bus communication requires a bus communication unit (GT15-QBUS/GT15-QBUS2).
2
GOT1000 Series
(SVGA / XGA)
Ethernet/ Bus connection
CNC CPU
Q173NCCPU
PLC CPU
QnUD(E)CPU
QnUD(E)HCPU
M E L S E C M E L S E C
POWER POWER
MITSUBISHI MITSUBISHI
Optical communication
Drive unit
CF card
LED
Rotary switch