Mitsubishi Electric C70 Setup Manual page 542

P72 NO HELICAL SPEC
Details
A helical command has been issued though it is out of specifications.
Remedy
- Check whether the specifications are provided for the helical cutting.
- An Axis 3 command has been issued by the circular interpolation command. If there is no helical
specification, move the linear axis to the next block.
P90 NO THREAD SPEC
Details
A thread cutting command was issued though it is out of specifications.
Remedy
- Check the specifications.
P93 SCREW PITCH ERR
Details
An illegal thread lead (thread pitch) was specified at the thread cutting command.
Remedy
- Correct the thread lead for the thread cutting command.
P111 PLANE CHG (CR)
Details
Plane selection commands (G17, G18, G19) were issued during a coordinate rotation (G68) was being
commanded.
Remedy
- Always command G69 (coordinate rotation cancel) after the G68 command, and then issue a plane
selection command.
P112 PLANE CHG (CC)
Details
- Plane selection commands (G17, G18, G19) were issued while tool radius compensation (G41, G42)
and nose R compensation (G41, G42, G46) commands were being issued.
- Plane selection commands were issued after completing nose R compensation commands when
there were no further axis movement commands after G40, and compensation has not been
cancelled.
Remedy
- Issue plane selection commands after completing (axis movement commands issued after G40
cancel command) tool radius compensation and nose R compensation commands.
P113 ILLEGAL PLANE
Details
The circular command axis does not correspond to the selected plane.
Remedy
- Select a correct plane before issuing a circular command.
P122 NO AUTO C-OVR
Details
An auto corner override command (G62) was issued though it is out of specifications.
Remedy
- Check the specifications.
- Delete the G62 command from the program.
P130 2nd AUX. ADDR
Details
The 2nd miscellaneous function address, commanded in the program, differs from the address set in
the parameters.
Remedy
- Correct the 2nd miscellaneous function address in the program.
C70 Setup Manual
Appendix 2.13 Program Errors (P)
525