Setting Multi-Cpu Parameters - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
4 CNC CPU Initial Setup

4.3 Setting Multi-CPU Parameters

Set CNC CPU module's parameters from GOT's CNC monitor screen.
(1) Turn ON the CNC CPU module. Turn ON the GOT, and display the utility's main menu. The utility call key(s) is set
as follows at factory shipment.
For GT15: Press the right and left top corners together.
For GT16: Press the left top corner.
(Note 1) After turning the power ON, it takes approximately fifteen seconds for GOT to start.
(Note 2) The utility call key(s) can be arranged on the "GOT Setup" screen. For details, refer to the following
manuals.
For GT Designer3: "GT Designer3 Version1 Screen Design Manual (Fundamentals)" (SH(NA)-080866),
Section 4.
For GT Designer2: "GT Designer2 Version2 Screen Design Manual" (SH(NA)-080530), Section 3.
82