Mitsubishi Electric C70 Setup Manual page 288

【#2281(PR)】 SV081 SPEC2 Servo specification 2
Select the servo functions.
A function is assigned to each bit.
Set this in hexadecimal format.
bit F-A :
Not used. Set to "0".
bit 9 : npg Earth fault detection
0: Disable
Set "0" and it is constantly "Enable" for MDS-DJ-V1/V2 Series.
bit 8 :
Not used. Set to "0".
bit 7 : szchk Distance-coded reference scale reference mark
0: Check at 4 points (standard)
bit 6-4 :
Not used. Set to "0".
bit 3 : absc Distance-coded reference scale
0: Disable
bit 2-0 :
Not used. Set to "0".
1: Enable (standard)
1: Check at 3 points
1: Enable
C70 Setup Manual
Appendix 1.5 Servo Parameters
absc
szchk
npg
271