Mitsubishi Electric C70 Setup Manual page 205

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1110】 M96_M M96 alternate M code
Set an M code to replace M96 when "#1109 subs_M" is set to "1".
---Setting range---
3 to 97 (excluding 30)
【#1111】 M97_M M97 alternate M code
Specify an M code to replace M97 when #1109 subs_M is set to 1.
---Setting range---
3 to 97 (excluding 30)
【#1112(PR)】 S_TRG Validate status trigger method
Select the enable conditions for the user macro interrupt signal (UIT).
0: Enable when interrupt signal (UIT) turns ON
1: Enable when interrupt signal (UIT) is ON
【#1113(PR)】 INT_2 Validate interrupt method type 2
Select the performance after user macro interrupt signal (UIT) input.
0: Execute interrupt program without waiting for block being executed to end
1: Execute interrupt program after completing block being executed
【#1114】 mcrint Macro argument initialization
Select whether to clear statements other than specified arguments by macro call.
Also select whether to clear local variables by power-ON and resetting.
0: Clear the non-specified arguments by macro call.
1: Hold non-specified arguments by macro call
2: Hold non-specified arguments by macro call, and clear local variables by power-ON and
【#1115】 thwait Waiting for thread cutting
Set the queue number during screw thread cutting when chamfering is disabled.
---Setting range---
0 to 99 (Approx. 4 ms)
Standard setting value: 4
【#1116】 G30SLM Invalidate soft limit (manual operation)
Enable this function when disabling the soft limit check function at the second to fourth reference
position return.
0: Enable soft limit function
1: Disable soft limit function
【#1117(PR)】 H_sens Handle response switch
Not used. Set to "0".
【#1118】 mirr_A Select how to set up the length of tools on cutter tables (opposed tables)
(for L system only)
Select one of the following two methods:
- Set the current length of tools on each facing turret.
- Set a value, assuming that the tools on each facing turret are in the same direction as that of those
on the base turret.
0: Current length of the tools on each facing turret
1: Value, assuming that the tools on each facing turret are in the same direction as that of those on
【#1119】 Tmiron Select the mirror image of each facing turret with T command (for L system
only)
Select whether to enable the mirror image of each facing turret with the T command.
0: Disable
1: Enable
188
resetting
the base turret