Setting The Coordinate System Offset - Mitsubishi Electric 700 Series Training Manual

3. Setup Screen

3.6.1 Setting the Coordinate System Offset

Operation method (Setting the workpiece coordinate system G54 - G59 offset amount)
(1) Press the
G54-G59
(2) Use the (
cursor to the workpiece coordinate system
offset to be set.
Use the
,
Refer to the "Changing the offset amount using the page change keys (previous page:
next page:
(3) Use the ↑ , ↓ keys to move the cursor
to the axis for which data is to be set.
(4) Set the offset amount.
122 INPUT
This setting can be made by pressing the
menu =INPUT key instead of the
INPUT key.
(5) Set other data using the same method.
(Note) It is possible to perform additional input by pressing the menu +INPUT key instead of the
INPUT or menu =INPUT keys.
[Ex.] If the original data is 122.000:
1.234 [+INPUT] → 122.000 + 1.234 = 123.234
Setting the external coordinate system offset amount
Set the external coordinate system offset amount to keep the current workpiece coordinate system offset
amounts from G54 to G59, and also apply an offset to the entire system.
Furthermore, it is also possible to use the data transfer function to write data directly to the external
coordinate system offset (EXT).
menu.
, ) keys to move the
page keys to change the coordinate system display.
)" section in "3.6.4 Changing the coordinate system display" for further details.
3.6 Workpiece Coordinate System Offset
The G54 - G59 workpiece coordinate system offset displays.
The set data displays and the cursor moves to the next data.
127
,