Mitsubishi Electric 700 Series Training Manual page 230

5. Diagnosis Screens
Menus
Menu
This erases the information in the line where the cursor is. (One entire
Line
clear line becomes blank.) The cursor does not move at this time.
The contents of the set address data (Part system No,
Section/sub-section/axis) for all the lines are constantly displayed.
Data
read
The Index No. highlight (indicating data is being set) is released.
The cursor appears in "Part system No" of that line.
This writes the data (Note) in the setting area to the NC memory
indicated by address data at the cursor position.
Data
The Data No. highlight (indicating data is being set) is released, and
write
constant display is started.
After writing, the cursor moves to "Part system No" of the next line.
Based on the data of the address data where the cursor is, this
displays the continuous data to which the sub-section No. has been
Subsect
continu
added to the address data from the line where the cursor is.
The cursor moves to "Part system No " of that line.
Based on the data of the address data where the cursor is, this
displays the continuous data to which the axis No. has been added to
Axis
continu
the address data from the line where the cursor is.
The cursor moves to "Part system No " of that line.
(Note) Decimal, hexadecimal, floating point data and character string data writing is possible.
Note that hexadecimal, floating point data and character strings may not be settable depending on the
data.
Decimal
Hexadecimal
Floating point data
Character string data : Character string .............................. (Example) X
5.5 NC Memory Diagnosis Screen (NC Memory Diagn Screen)
Details
: Integers without decimal points ...... (Example) -1234
: An "H" is necessary at the end ....... (Example) 1234H
: Data with a decimal point................ (Example) -12.3
222
Type Reference
C
C 5.5.1 Writing/Reading
the Data Using the NC
Data Designation
A
C
C