Mitsubishi Electric 700 Series Training Manual page 139

3. Setup Screen
Display items
Display item
(1) Measurement counter
Surface measurement
counter
Hole measurement
counter
Width measurement
counter
Rotation measurement
counter
(2) Manual measurement
status display
(3) Guide drawing
(4) Sensor length and
diameter
(5) Coordinate system offset
(6) Measurement position
counter
(7) Center shift amount
(8) Coordinate rotation center Displays the coordinates that are the center during coordinate rotation.This is the
(9) Coordinate rotation angle
Displays the measurement position.
The measurement axis is compatible with base system parameters "#1026 base_I",
"#1027 base_J", and "#1028 base_K". (Hereafter indicated as I=X, J=Y, and K=Z
axes in this manual.)
The measurement position becomes blank when setting the coordinate system offset
amount, resetting the NC, or changing the measurement mode (when face meas,
hole meas, width meas, or rotate meas menu is selected).
The display contents differ depending on the measurement pattern (surface
measurement, hole measurement, width measurement, or rotation measurement).
Displays the calculated measurement position from the skip position for each axis (X-,
Y-, Z-axes).
Displays 3 (A, B, C) measurement positions (X-, Y-axes).
Displays 2 (A, B) measurement positions (X-, Y-, Z-axes).
Displays 3 (A, B, C) measurement positions (X-, Y-axes).
Displays the manual measurement status.
Refer to the "Manual measurement status display" section in "3.3.1 Tool
Measurement (M system)" for further details.
Displays the measurement image.
The contents of the guide drawing differ depending on the measurement pattern
(surface measurement, hole measurement, width measurement, or rotation
measurement).
Sensor length : Displays the length to the tip of the touch sensor.
("#8701 Tool Length" setting value)
Sensor diameter : Displays the diameter of the ball at the tip of the touch sensor.
("#8702 Tool Dia" setting value)
Displays the currently selected coordinate system offset.
Displays the measurement position for all axes.
X axis : X axis machine position + sensor radius +center compensation (Horizontal)
Y axis : Y axis machine position + sensor radius +center compensation (Vertical)
Z axis : Z axis machine position - sensor length
4th axis and over : Respective machine position
Sensor length
Sensor radius
Center compensation (H)
Center compensation (V)
Displays the shift amount of the coordinate rotation center.
setting value of "#8623 Coord rot centr (H)" and "#8624 Coord rot centr (V)".
Displays the rotation angle during coordinate rotation.This is the setting value of
"#8627 Coord rot angle".
131
3.7 Workpiece Measurement
Details
: "#8701 Tool Length"
: "#8702 Tool Dia"/2
: "#8703 OFFSET X"
: "#8704 OFFSET Y"