Mitsubishi Electric 700 Series Training Manual page 121

3. Setup Screen
Operation method (Designating a group No.) (M system)
(1) Press the
Group No menu.
(2) Designate the group No. to be displayed.
12 INPUT
(Note) If a group No. that does not exist is designated, a message appears to confirm the creation of a
new No. A new group is created if Y or INPUT is pressed.
Operation method (Changing a group No.)
(1) Press the
Grp No. change
(2) Designate the group No. after changing.
112 INPUT
(Note) An error occurs if the group No. duplicates a pre-existing group No.
Operation method (Setting the tool life data) (M system)
(1) Move the cursor to the data to be set using
the , ↑ , ↓ ,
keys.
It is possible to move to the line after the
registered line.
Set a tool No. for this line to newly register
tool life management data.
(2) Set a value.
20 INPUT
(Note 1) The other settings will be invalid when the tool ST (status) setting data are not set.
(Note 2) The same tool cannot be registered in more than one group.
(Note 3) If the tool No. is not set, the other data cannot be set.
(Note 4) Change the " Method " to initialize the related items.
Change the tool life management method (the 1st digit) to clear the " Life " and " Usage " , and also
change the units.
Change the tool radius compensation data (the 2nd digit) to clear the " Radius Compensation " .
Change the tool length compensation data (the 3rd digit) to clear the " Length Compensation ".
Figures after the decimal point are also changed in line with the specifications.
The menu is highlighted.
The tool life data of the designated group No. appears, and
the cursor moves to the head of the data.
(M system)
The menu is highlighted.
menu.
The group No. changes to " 112 " .
The menu is highlighted.
and
The set value displays.
The cursor moves one position to the right.
113
3.5 Tool Life Management