Hitachi GR2000 Series Configuration Commands page 107

Parameter
Description:
Default:
Description:
in:
out:
Default:
Description:
Default:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Description:
Default:
GR2K-GA-0014
Ver. 07-02
Specifies the subject interface name set in the ip information
or ip-address information. (The ip information or the ip-address
information should be set before inputting this command.) RM
Ethenet and Tunnel interface are not supported. For details,
refer to Table 1-5.
No default is possible.
Specifies the Inbound/Outbound. Either one or both of the
Inbound/Outbound can be set against one interface.
Inbound (specification of the frame input side)
Outbound (specification of the frame output side)
No default is possible.
Nullifies the flow control by input/output interface.
Flow control is executed.
Specifies the list number.
Default is possible only in the indicated case. All the lists are
displayed at default.
1 to 20,000 (ten-decimals)
Specifies the range of a list number. This parameter can be
specified only when a blank list number is displayed.
The range of the list number being the object of indication will
the number of all the lists totaling the IPv4QoS list and
IPv6QoS list.
1-255 (decimal) are designated to <No>. (Ver. 05-01, Ver.
06-00)
1-1000000 (decimal) are designated to <No.>. (Ver. 06-01)
Displays the blank list number.
Cannot be omitted when the blank list number is displayed.
Displays the top blank list number in the specified range.
Cannot be omitted when the top list number of a blank list
number is displayed.
Filtering/QoS Information
1-65