Hitachi GR2000 Series Configuration Commands page 449

Table 5-6
pim: invalid max-interfaces value at '<Num>'
pim: mask not contiguous
pim: Non-masked bits not zero for <Group
address> / <Masklen>
pim: Non-masked bits not zero for <Group
address> mask <Mask>
pim: Non-masked bits not zero for <Group
address> masklen <Masklen>
pim: octet or hex string too long to be an IP
address
pim:ssm is not defined
pim: the parameter must be a group address
(class D)
pim: the total number of enable interfaces is
more than the max-interfaces value (<Num>)
GR2K-GA-0014
Ver. 07-02
Multicast Router Control Information Error Messages (continued)
PIM-SM does not support max-interfaces values.
<Num>: The maximum number of specified interfaces
The specified mask for rendezvous point candidates of PIM-SM is
not continuous at bit 1. Specify a mask that is continuous at bit 1.
In the group of rendezvous point candidates of PIM-SM, the
non-mask bit of the specified masklen address is set to "1." Set the
non-mask bit to "0."
<Group address>: specified multicast group address
<Masklen>: Specified mask length
In specifying a mask for the group of rendezvous point candidates of
PIM-SM, the non-mask bit of the specified address is set to "1." Set
the non-mask bit to "0."
<Group address>: specified multicast group address
<Mask>: Specified mask
In specifying masklen for the group of rendezvous point candidates
of PIM-SM, the non-mask bit of the specified address is set to "1."
Set the non-mask bit to "0."
<Group address>: specified multicast group address
<Masklen>: Specified mask length
The specified IP address format is abnormal. Specify the correct dot
format.
Though the "ssm-join" command has been defined, the "ssm"
command has not been defined.
The group address specified for rendezvous point candidates of
PIM-SM is illegal. For the group address, specify a Class-D IP
address.
The total number of interface addresses specified to be enable in the
pim definition has exceeded the value specified by max-interfaces
(<Num>). Specify the addresses so that the number of interface
addresses specified to be enable is less than the value specified by
max-interfaces (<Num>). The maximum value for the max-interfaces
is 256. If addition of the interface definition for PIM is wanted, add the
definition after having increased the value of the max-interfaces.
If deletion the interface definition of PIM is wanted, delete the
interface definition so that the number of interface addresses
specified to be enable is less than the value of the max-interfaces
(<Num>).
<Num>: Specified number of the maximum interfaces.
Configuration Error Messages
5-59