Hitachi GR2000 Series Configuration Commands page 115
Hitachi gigabit router configuration guide
Hide thumbs
Also See for GR2000 Series:
- Installation manual (18 pages) ,
- Installation manual (410 pages)
Table of Contents
Advertisement
when the group number has been previously set in the QoS interface
information. Designate this parameter's out (Outbound) as the flow control of the
output side. When this parameter is designated, only "-priority" and "-discard"
can be set. The setting range for "-priority" is from one to four. This parameter
cannot be set if the output line is a VLAN line.
Default:
Range of value
This parameter enables the function that rewrites a DSCP value and that
determines the output priority and queuing priority using the rewritten DSCP
value. The DSCP value and its corresponding output priority and queuing priority
are specified using a qos-tos-map command. This parameter rewrites the DSCP
value that is the upper six bits of a TOS field. The lower two bits of a TOS field are
not rewritten.
7
2
DSCP (Differentiated Services Code Point), CU (Current Unused)
Default:
Range of value:
This parameter enables the function that determines the output priority and
queuing priority using the DSCP value of an input packet. The DSCP value and
its corresponding output priority and queuing priority are specified using a
qos-tos-map command. The upper six bits of a TOS field in a receive packet are
treated as a target. The lower two bits of a TOS field are ignored. -priority,
-discard, and -replace_dscp cannot be set when this parameter is set.
DSCP (Differentiated Services Code Point), CU (Current Unused)
Default:
Specifies the operation when the contract band is breached.
GR2K-GA-0014
Ver. 07-02
None
The group number designated by the qos-interface (QoS
interface information).
6
5
4
2
2
2
DSCP
High-Order 6 Bits are Designated
priority: 4
discard: 4
-replace_dscp <DSCP_Value>: 0 to 63 (decimal).
7
6
5
2
2
2
DSCP
High-Order 6 Bits are Designated
priority: 4
discard: 4
Packet discard.
Specifies the queuing priority after having been changed. If
this parameter is specified and the out put line is ATM, it is
possible to set the cell loss priority indication bit (CLP bit) of a
3
2
1
0
2
2
2
2
CU
4
3
2
1
2
2
2
2
CU
Filtering/QoS Information
0
2
1-73
Advertisement
Table of Contents
