Table 1-89 Range Of Priority Class And Discard Class - Hitachi GR2000 Series Configuration Commands

Default:
Range of value:

Table 1-89 Range of Priority Class and Discard Class

Max. Output
Priority
Omitted
Omitted
Omitted
Omitted
Omitted
Omitted
8
16
32
*1: When the value other than the range is specified to output priority, the setting becomes invalid.
*2: When queue count of output interface is 250 or 1000, flow control is processed as follows:
• Queuing priority 1, 2: Flow control is processed by queuing priority 2.
• Queuing priority 3, 4: Flow control is processed by queuing priority 4.
Description:
Default:
Range of value:
Description:
Default:
Range of value:
This parameter is validated in lists other than the normal packet of maximum
band limitation or minimum band guarantee.
This parameter is valid only in RP-C, RP-D, RP-C6, RP-D6, RP-CV, RP-DV,
GR2000-1B and GR2000-2B.
GR2K-GA-0014
Ver. 07-02
Sets the output priority class after changes. Used as the
output priority class when the output priority control is used,
and used as a queue number when the bandwidth and
round-robin scheme are used.
Sets the queuing priority after changes.
Setting Condition
Interface Using Queue Count of
This List Output Interface
Input side --
Output side 8
Output side 16
Output side 32
Output side 250
Output side 1000
-- --
-- --
-- --
This parameter specifies the rewrite value of an EXP field.
None
0-7
his parameter sets the burst size in units of bytes during band
monitoring.
None (The burst size is not considered during band
monitoring.)
1 to 131,072 (decimal)
Filtering/QoS Information
Range
Output Priority Queuing Priority
1-8 1-4
1-8 1-4
1-16 1-4
1-32 1-4
1-250 1-4 (*2)
1-1000 1-4 (*2)
1-8 1-4
1-16 1-4
1-32 1-4
1-181