Hitachi GR2000 Series Configuration Commands page 128

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 1-46 List of Parameters that Can Be Set for Each RP Type Using IPv6 QoS
Item
Main Item Sub-Item
Designation Contract band
of operation monitoring
Output priority
Queuing priority
DSCP rewrite
Decision of priority by
using DSCP of input IP
packet.
Abortion at contract
band breach.
Queuing priority at
contract band breach.
DSCP rewriting at
contract band breach.
Connection branch
Group number
User priority rewrite
: Can be set.
-: Cannot be set.
*1): Can be set for uni-cast Cannot be set for multi-cast.
*2: Can be set only on GR2000-1B, GR2000-2B and GR2000-2B+.
Action parameters also have parameters decided that can be set according to type of
actions. Comparative table is shown below for action parameters that can be set by
actions
The flow control type can be divided largely into 11 control types.
Control 1:
Determines the priority using the output priority.
Control 2:
Determines the priority using the output priority and performs surveillance on
the contract band. If the detected flow breaches the contract band, abolishment
processing is performed.
Control 3:
Determines the priority using the output priority and performs surveillance on
the contract band. If the detected flow breaches the contract band, the priority is
lowered.
1-86
Information.
Parameter
-upc <kbps>
-upc_burst <Byte>
-min_rate <kbps>
-min_rate_burst
<Byte>
max_rate <kbps>
max_rate_burst
<Byte>
-priority <No.>
-discard <No.>
-replace_dscp
<DSCP_Value>
-dscp_map
-penalty_drop
-penalty_discard
<No.>
-penalty_dscp
<DSCP_Value>
-index <No.>
-group<No.>
-replace_user_priority
<No.>
RP-A1 RP-C, RP-D
Input Output Input
Side Side Side
- -
RP-C6, RP-D6,
RP-CV, RP-DV
GR2000-1B/2B
Output Input Output
Side Side Side
- -
GR2K-GA-0014
Ver. 07-02