Table 1-85 List Of Igmp Type Number - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Default:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:

Table 1-85 List of IGMP Type Number

IGMP Type No. (HEX)
0x11
0x12
0x13
0x16
0x17
0x22
Description:
Default:
Range of value:
1-174
Checks the source and the destination IP addresses, and
upper-level source and destination protocol port numbers by
simultaneously switching the values (synchronized check). To
run the synchronized source and destination IP address
check, specify:
-ip_pair_off
number check, specify:
pair_synchronized_off
-
This parameter specifies the ICMP type.
None (ICMP type is not a flow detection condition).
0-255
This parameter specifies the ICMP code.
None (ICMP code is not a flow detection condition).
0-255
This parameter specifies the IGMP type.
None (IGMP type is not a flow detection condition).
0-255
Input Value (Decimal)
17
18
19
22
23
34
This parameter specifies a connection branch Index number
(DLCI group information or Index specified using VC-Group
information). This parameter selects and sends the specified
DLCI/VC information in a group when it relays a packet that
coincides with QoS IP frame conditions. For the QoS IP frame
conditions under which the connection branch Index number
is set, specify parameter -out (Outbound) and set it as QoS IP
frame conditions on the output side when setting IP QoS
information. See 1.2.8 in this guide.
None
0-7
. For the synchronized port
(see note 1).
-port_pair_ off
Name
Membership Query
Version 1 Membership Report
DVMRP protocol
Version 2 Membership Report
Version 2 Leave Group
Version 3 Membership Report
GR2K-GA-0014
Ver. 07-02