Table 1-27 List Of Interfaces Supporting Flow Control - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Operation Parameter
If the operation parameter is either set or changed, please be sure to set this
parameter at the head of the whole operation parameter.
Default:
Range of value:
Operation which agrees with the flow detecting condition is designated.
-forward:The agreed package is relayed.
-drop :The agreed packet is discarded.
Default:
Range of value:
The policy routing function is made effective. When relaying a packet that agrees
with the filter condition, the packet is transmitted to the output destination
designated by this option. Designate "in" (Inbound) for the list information that
has set the policy routing, as the flow control of the reception side.
<Interface Name>: Designate the interface name of the output destination (the
interface name set in the IP information). (Refer toTable 1-27.))

Table 1-27 List of Interfaces Supporting Flow Control

Interface Name
<Line Name>
RmEthernet
<DLCI Name>
<VC Name>
<Group Name>
<Timeslot Name>
<Peer Name>
<Tunnel Name>
<VLAN Name>
<Session Name>
: Setting possible.
-: Setting impossible
*1: VLAN line and PPOoE session are not supported.
Default:
Range of value:
Class A : 1.0.0.1-126.255.255.254
Class B : 128.1.0.1-191.254.255.254
Class C : 192.0.1.1-233.255.254.254
1-34
None (No default is possible when designating the operation.)
None
-forward
None
Availability of Support
---
---
---(1*)
--- (1*)
forward
<IP Address>: Set the IPv4 addresses shown below:
GR2K-GA-0014
Ver. 07-02