Log Information; Logger-Syslog - Hitachi GR2000 Series Configuration Commands

4.2

Log Information

Caution:
!
4.2.1

logger-syslog

Function
Object for creation, deletion, and display of the logger setup, i.e., configuration
information necessary for log information output on the syslog interface. Up to 20 of
such entries can be registered.
Input format
To create a logger setup entry:
Parameter
Description:
Description
Description:
Description:
GR2K-GA-0014
Ver. 07-02
Regarding log Information, this object must be used in conjunction with the
configuration subcommand. LOG information can be sent to other devices on the
network by the following methods:
1. Sends to the device with syslog function (UNIX workstation, etc.) by using syslog
interface. This function enables centralized control of log when controls many
devices.
2. Sends by e-mail. This function enables centralized control of log when controls
many devices.
Specifies the logout destination host name.
This parameter specifies the facility of syslog.
This parameter specifies one of local0, local1, local2, local3,
local4, local5, local6, and local7. The initial value when this
parameter is omitted is local0.
Specifies the logout level on the syslog interface. Only one
among emerg, alert, crit, err, warning, notice, info, and debug
can be selected.
Specifies the event level for the logout. Only one among key,
rsp, rtm, err, evt, mrp, mpl, ip6 and mr6 can be selected.
Operation Management Information
4-7