Table 4-4. List Of Initial Value Items That Can Be Set Using Line Information (Wan) And Initial Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

Table 4-4
Information
Information Name
Group Name
line Information Selection of physical layer frame format in
(WAN) E1
Selection of physical layer line code
format in E1
Selection of synchronized clock in E1
Setting value of national bit in E1
Selection of timeslot line rate in E1
Selection of synchronized clocks in T3
CRC length in T3
Selection of scramble disable/enable in T3 Disable (-t3_scramble_off)
Selection of installation position in T3
network
Selection of acceptance during remote
loop-back test request in T3
Selection of MDL message in T3
Selection of physical layer frame format in
T1
Selection of physical layer line code
format in T1
Selection of synchronized clock in T1
Selection of timeslot line rate I T1
Selection of installation position in T1
network
Selection of FDL type in T1
Selection of acceptance during remote
loop-back test request in T1
Selection of PRM transmission/response
in T1
Selection of synchronized clock in E3
Setting value of national bit in E3
CRC length in E3
Selection of scramble disable/enable in E3 Disable (-e3_scramble_off)
line Information Selection of synchronized multi-clock in
(WAN) E3
(continued)
Setting value of national multi-bit in E3
Multi-CRC length in E3
Selection of physical layer multi-frame
format in E3
Selection of synchronized multi-clock in T3 Synchronized with the clock in a local router.
Multi-CRC length in T3
GR2K-GA-0014
Ver. 07-02
List of Initial Value Items that Can Be Set Using line Information (WAN) and
Initial Values During Initial Installation
Operation Management Information
Initial Value
CRC-4 Multiframe (crc4)
HDB3(High Density Bipolar 3)(hdb3)
Synchronized with the received clock. (external)
0 (hexadecimal)
7 6 5
(2 : SI, 2 : Unused, 2 : Unused, 2
3 2 1
2 : SA-5, 2 : SA-6, 2 : SA-7, 2
64 kbps (64)
Synchronized with the clock in a local router.
(independent)
16 (bits)
CI(Customer Installation) (ci)
The remote loop-back test request can be accepted.
The loop-back type specifies payload loop-back.
(payload)
MDL stops. (disable)
ESF(Extended Superframe) (esf)
B8ZS (Bipolar with 8 Zeros Substitutions) (b8zs)
Synchronized with the received clock. (external)
64 kbps (64)
CI(Customer Installation) (ci)
AVSI T1.403(ansi)
The remote loop-back test request can be accepted.
(auto)
The PRM transmission/response is enabled. (enable)
Synchronized with the received clock. (external)
0 (Na = 0)
16 (bits)
Synchronized with the received clock. (external)
0 (Na = 0)
16 (bits)
C-bit parity frame (cbit)
(independent)
16 (bits)
4
: SA-4,
0
: SA-8)
4-37