Table 1-45 Number Of Entries Used Per List By Each Setting - Hitachi GR2000 Series Configuration Commands

Specifies the rewriting value for the EXP field.
(This parameter is valid for RP-CV and RP-DV.)
Default:
Range of value:
Specifies the rewriting value for user priority.
Use this parameter to specify "out" (outbound) VLAN line information as flow
control on the outbound side. When this parameter is set, it is only possible to
set -priority, -discard and -replace dscp.
Default:
Range of value:
The number of entries used per list as a result of setting the important packet
protecting function, maximum band restriction, and minimum band assurance is as
shown in Table 1-45.

Table 1-45 Number of Entries Used per List by Each Setting

Setting Contents
No setting
Maximum band restriction
Minimum band assurance
Maximum band restriction + minimum band assurance
Maximum band restriction + important packet protection
Minimum band assurance + important packet protection
Maximum band restriction +minimum band assurance +
important packet protection
: With setting. No mark : Without setting
Input Examples
1. Setting the IPv4 QoS flow information
Classification of packets:
In order to preferentially transfer the packets with the transmitter IP
addresses of 10, 10, 10, 2, the high-order protocol of TCP, and with the
destination port number of 23 (telnet), the output priority class of the said
packets are specified as seven and that of other packets as one.
GR2K-GA-0014
Ver. 07-02
None.
0 to 7.
None
0 - 7
-premium
Filtering/QoS Information
Setting Parameter
-max_rate -min_rate
Number of
Entry
1
1
1
2
2
2
4
1-75