Hitachi GR2000 Series Configuration Commands page 177

Default:
Description:
Default:
-wan_length_mode { short | long}
Description:
Default:
Example
1. Setting QoS parameters
To enable flow control:
GR2K-GA-0014
Ver. 07-02
: enable
-yes
no
This parameter uses all interfaces by a COPS function.
None (All interfaces are not used by a COPS function.)
Designates in the device unit the length of a hardware queue
that is used in frame transmission to WAN lines smaller than 6
M bit/s (serial, BRI, PRI, J2, BRIISDN, PRIISDN, T1, ED) and
the E3 multiplex line.
Short: Hardware queue length gives the transmission delay
time higher priority.
Long: Hardware queue length gives performance higher
priority.
Short.
Filtering/QoS Information
1-135