Qos-Tos-Map - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5. Deleting settings:
a. Deleting the list in the group
To delete QoS IP frame condition list number 9 of the QoS IP frame condition
group named
b. Deleting the group:
Related Commands
qos-queue-list
qos-interface
qos-discard-mode
qos-ip-list

qos-tos-map

qos-ip
Related Information
For the flow control, refer to the GR2000 Applications Guide.
Precautions
1. The determination of QoS occurs in the order of the QoS IP frame condition list
number designated in the QoS IP frame condition group.
2. QoS IP frame condition group cannot be deleted while in use with IP QoS
settings.
3. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
1.2.7 qos-tos-map
This command sets the TOS-QoS conversion table information. A maximum of eight
entries (precedence) can be created.
1-196
:
ip1
To delete the QoS IP frame condition group named :
ip1
GR2K-GA-0014
Ver. 07-02