Change Record - Hitachi GR2000 Series Configuration Commands

Release 06-05 (December 2002)
This publication contains the most current information available to date. As new and
revised sections are received, new updates will be distributed.
Notice: No part of this publication may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopying and recording, or
stored in a database or retrieval system for any purpose without the expressed
written permission of Hitachi, Ltd.
Hitachi, Ltd. reserves the right to make changes to this document at any time
without notice, and assumes no responsibility for its use. All the features described
in this document may not be currently available.

Change Record

Revision
No.
0
1
A
B
C
3.02
4.00
5.00
6.01
06-05
Preface
This manual provides a product overview and component details of the GR2000
Gigabit Router Series, and discusses various aspects of product installation,
including pre-installation planning, site preparation, unpacking and setup, adding
and removing modules, and starting and stopping the router. The manual is
intended for personnel involved in the installation and initial setup of the GR2000
Gigabit Router Series. Make sure that you read and understand the Safety section of
this manual before beginning installation.
This GR2000 Configuration Commands, Vol. 2 is one of a set of manuals describing
the GR2000 Gigabit Router Series. The table below lists the entire set and provides
the full name of the manual. All titles are for version 06-05 unless otherwise noted.
GR2K-GA-0014
Ver. 07-02
Date Description
February 2000 Original edition.
March 2000 Conversion to HICAM format
July 2000 Edit for Revision A
August 2000 Edit by ESD
November 2000 Release 3.00
January 2001 Release 3.02
May 2001 Release 4.00
July 2001 Release 5.00
July 2002 Release 6.01
December 2002 Release 06.05, Reorganized Configuration Guide
into three volumes: Settings, Vol. 1, and Vol. 2.
Affected Pages
—
All
All
All
All
All
All
All
All
All
iii