Chapter 1 - Filtering/Qos Information - Hitachi GR2000 Series Configuration Commands

This is the second of two volumes detailing the configuration commands for the
Hitachi GR2000 Gigabit Router Series. This manual is organized into five chapters:
Chapter 1 provides information regarding filtering and QoS, including flow
information, QoS objects, and COPS.
Chapter 2 covers IPX and bridge objects
Chapter 3 covers SNMP objects
Chapter 4 provides operation management information, including information
about host name, logs, NTP, board disablement, and default configuration
objects.
Chapter 5 is a complete list of all configuration error messages.
The first volume of commands, Hitachi Gigabit Router GR2000 Series Enhanced
Version Configuration Commands, Vol. 1, covers the following areas in seven
chapters:
Chapter 1 provides a configuration command overview, and an introduction to
configuration subcommands.
Chapter 2 describes the router management object - router.
Chapter 3 provides command information about the network interface, including
line objects, link layer protocol objects, ISDN objects, the group information
object - group, tunnel information, and backup.
Chapter 4 cover IP commands, including IP information objects, ndp, ra, VRRP,
policy routing, DHCP relay, DHCP server, and DHCP client information, and
address translation information.
Chapter 5 provides information about IP routing protocol objects
Chapter 6 is for IP and IPv6 multicast routing protocol commands.
Chapter 7 covers MPLS commands.
In addition, the Hitachi Gigabit Router GR2000 Series Enhanced Version
Configuration Settings manual provides extensive configuration examples contained
in the following three chapters:
Chapter 1 is general information about configuration
Chapter 2 is a configuration overview
Chapter 3 provides configuration examples for the commands covered in both
volumes of configuration command manuals.
GR2K-GA-0014
Ver. 07-02
Filtering/QoS Information
Chapter 1
1-1