Hitachi GR2000 Series Configuration Commands page 222

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Default:
range of value:
Description:
Default:
Description:
Default:
Range of value:
Description:
D (Delay),T (Throughput), R (Reliability)
DSCP (Differentiated Services Code Point), CU (Current Unused)
1-180
-priority_class 4 -discard_class 4
flow control set by queuing priority class)
-replace_tos <New_Tos Value>:0-255
This parameter makes the function of QoS control by TOS
input valid.
When this parameter is set,
and
-replace_tos
(output priority class, flow control by setting queuing priority
class)
This parameter sets the use of the agreed band monitoring
function and the agreed band.
Unused
Sets the agreed band in bit/s. If the number is greater than
the circuit speed, performance ends.
-upc no
<Bandwidth>:0-1000000000
If a number from
contract field is 12000 [bit/s].
This parameter sets the performance at the time of the
violation of the agreed band.
Drops the frame.
Sets the number replacing TOS or DS field of Diff-serv, and
QoS control by replaced TOS or DS field of Diff-serv. The upper
6 bits of the TOS or DS field of Diff-serv field are replaced. The
lower 2 bits are ignored even if this parameter is set.
7 6 5 4
2 2 2 2
Pprecedence D
High-order 6 bits are designated.
7 6 5 4
2 2 2 2
DSCP
High-Order 6 Bits are Designated.
-priority_class
cannot be set.
(0-1G)
is set, performance continues, as the
0-11999
3 2 1 0
2 2 2 2
T R Unused
3 2 1 0
2 2 2 2
CU
(output priority class,
(Note 2)
,
-discard_class
GR2K-GA-0014
Ver. 07-02
,