Pv500 - Panasonic PV500 User Manual

1.1 PV500

1 Operating LEDs
2 Parallel I/O Connector
3 Reset Switch
4 COM0 Port
5 COM1 Port
COM2 Port
6 Parallel I/O Terminal Block
7 Power Input Terminal
8 SD Memory Card Slot
9 USB Port
10 Keypad Connector
11 Ethernet Port
12 MONITOR
13 Camera 0 Connect Port
14 Camera 1 Connect Port
15 Camera 2 Connect Port
(Only for 4-camera type)
16 Camera 3 Connect Port
(Only for 4-camera type)
17 Battery Case
10
Displays the status of the following signals and communication ports.
POWER / READY / ERROR0 / ERROR1 / COM.0 / COM.1 / COM.2
I/O interface, MIL connector type
Reboots PV500.
RS-232C Communication port.
Connects the cable of D-SUB 9 pin connector.
Not available.
Not available.
I/O interface, terminal block type
Supplies 24V DC through the included power cable.
Complies with SD memory card (SDHC) with up to 32 GB of memory.
During accessing to a SD memory card, the LED above the slot flashes.
USB 2.0 supported. (Exclusive for PVWIN communication)
Connects a keypad (ANPVP03 / ANPVP10).
Connects an Ethernet cable. When connecting an Ethernet cable, either
one of two LEDs lights. The LED to light and the color varies depending
on baud rate.)
Analog RGB output terminal. Connects a monitor.
Connects a camera 0.
Connects a camera 1.
Connects a camera 2.
Connects a camera 3.
Attaches the battery retaining the following information.
See the next page and attach the battery before use.
- Built-in calendar
- Type No. and Layout No. when turning off the power
- Status of keypad operation