Overview Of Tool - Panasonic PV500 User Manual

7.1 Overview of TOOL

With "TOOL" in SETUP menu, the following can be performed; settings, information display, and updating of
PV500 you use, adjustment support of optical parts and communication test at the introduction. In addition, you
can switch the mode to communication with PVWIN, which is software of setting and simulation for PV series.
PVWIN Comm. (supported in Ver.1.30 or later)
This switches the mode to communication with PVWIN, which is software of setting and simulation for PV
series.
General Settings
·
Startup Setting
Specify the Area No. to save the data which is read when PV500 starts up.
To specify a type No. and a layout No. to read at startup, select [ENVIRONMENT]. Refer to page 331 for
details.
·
Network
This is necessary setting to perform Ethernet communication.
·
Calendar
It adjusts the calendar in PV500.
Be sure to use this function attaching the battery that can be found set with no connection if you open the
lid on the back.
·
Language
This switches between languages of the menus.
·
Initialize
This restores the settings of PV to the default.
SD Property
This is for confirming the property of a SD memory card (such as saved contents or information of a SD
memory card).
Eject SD Card
Select this before ejecting a SD memory card from PV.
Information
It displays the version information on your PV500 and memory usage.
Setting Help
This function supports to make setting of optical parts of PV500, to confirm the communication, and its
adjustment for introduction.
• Focus Adjustment
• Aperture Adjustment
• Gray Data Analysis
• Capture Delay Control
• I/O Test
• Communication Test
Update
It performs upgrading of PV500 and customizing the splash screen.
344
To adjust focus of the lens. Rotate the focus ring of the lens following the
displayed message.
To adjust aperture of the lens. Rotate the aperture ring (iris ring) of the lens
following the displayed message.
To display the grayscale level of the image in the linear area in a graph form.
To decide optimum capture conditions by capturing and displaying images
while changing the condition for each camera.
To check the connections of I/O connector and I/O terminal block with the
external devices.
To test the communication with the external devices connected to COM.0 port
and Ethernet port.