Panasonic PV500 User Manual page 412

Read Out Command
This is a command that reads out the settings of PV500 and inspection results. For the information of readable
data, refer to the pages after page 380.
When reading one of data (such as Execution time,
Total judgement, Maximum value, or Minimum value)
Send % P R
% P R $
Receive
Error (ERROR 1 signal = ON)
% P R
Example: Reads out Execution time 1.
Send
% P R
Receive
% P R $ S Y S
When reading two of data (such as Maximum value and
Minimum value)
% P R P
Send
Receive % P R P
Error (ERROR 1 signal = ON)
% P R P
Example: Reads out the maximum and minimum values of slice level group "A".
Send
% P R P
Receive
% P R P
Error codes for Read Out command
200 Operation is stopped.
251 Specification of the parameter is wrong. (Undefined parameter is specified.)
252 The specified parameter does not exist. (e.g. You tried to read out the setting value of an
uncreated checker.)
410
Parameter BCC
Parameter =
! Error code (3-digit)
S Y S _ T I
_ T I
Parameter BCC CR
$ Parameter =
! Error code (3-digit)
B L V : P A
$ B L V : P A
CR
Data BCC CR
BCC CR
M E 1 BCC CR
M E 1 = 5 3 .
Data 1 , Data 2
BCC CR
I R A BCC CR
I R A = 8 0
Minimum
2 5 BCC CR
BCC CR
, 2 5 5 BCC CR
Maximum