Switching Types By Plc Communication - Panasonic PV500 User Manual

When PLC Type is Mitsubishi: MELSEC-Q (Ethernet unit)
Set to communicate with Ethernet unit QJ71E71-100.
1.
After selecting the PLC type, press "Set"
button of "PLC Communication Setting".
The setting window is displayed.
2.
Assign the IP address to the PLC.
3.
Specify the port number of the PLC.
Default: 5000
Input the same number as the port number set
on the PLC to communicate.
Available port No. on PV500: 1 to 65534 (except
8600 to 8699 and 9090)

9.3.3 Switching Types by PLC Communication

When outputting data through PLC communication, you can specify the product type to be switched by using
the protocol of PLC communication. For the timing of switching, it is necessary to turn on/off the TYPE signal by
parallel input.
Type Switching Flow
PV500
Receives TYPE signal.
Turns off ACCEPT signal.
Checks the value stored in the specified
address.
Switches to the Type of the stored
value.
Turns on ACCEPT signal.
Waits for the next signal.
426
PLC
Stores a Type No. to switch to in specified
address.
Verifies ACCEPT signal is on.
Outputs TYPE signal which switches types.
Turns off TYPE signal.
Outputs an inspection start signal or another
signal.