Panasonic PV500 User Manual page 420

Specifications of PLCs
In accordance with specification of PLCs, some of the registers in "Usable range" of "Usable device" listed
below could not be used. Please confirm the specifications of PLC before use.
FP series / FP series (ET-LAN unit) by Panasonic Industrial
Devices SUNX Co., Ltd.
·
Protocol: MEWTOCOL
·
Usable device
·
Sum check: Yes (type: BCC)
Q series / Q series Ethernet unit by Mitsubishi Electric
Corporation
·
Protocol:
- RS232C interface: "Format 4", 4C frame compatible for QnA
- Ethernet interface: 3E frame compatible for QnA
However, communication is only available with Ethernet unit QJ71E71-100.
·
Usable device
·
Make the following setting with PLC.
When using RS-232C Interface
- Sum check: Yes (type: BCC)
- Write at RUN time: "Enable"
When using Ethernet interface
- Communication data code: Binary code communication
- Initial timing setting: Always wait for OPEN
- Send frame setting: Ethernet(V2.0)
- Write at RUN time: "Enable"
A series by Mitsubishi Electric Corporation
·
Protocol: "Format 4", 1C frame compatible for A
·
Usable device
·
Make the following setting with PLC.
- Sum check: Yes (type: BCC)
- Modification in RUN mode: Available
FX series by Mitsubishi Electric Corporation
·
CPU: FX1N, Communication adapter: FX1N-232-BD
·
Protocol: Special protocol for FX1N
Register for specifying communication format: Store "0" in D8120. (Reboot the PLC after the setting.)
·
Usable device
·
Sum check: Yes
With PLC, you cannot select to perform sum check. Automatically "Yes" is selected.
418
Data output/ Type switch
Data output completion notice
Data output/ Type switch
Data output completion notice
Data output/ Type switch
Data output completion notice
Data output/ Type switch
Data output completion notice
DT
Register* WR (Usable Range: 0 to 999)
Bit 0-15 (0-F)
D
Register* M (Usable Range: 0 to 99999)
Bit Invalid
D
Register* M (Usable Range: 0 to 999)
Bit Invalid
D
Register* M (Usable Range: 0 to 9999)
Bit Invalid