Panasonic PV500 User Manual page 50

4.
Set the start point (a square mark) of the rectangle.
Move the start point by tilting the ENTER key and press it to determine the position.
5.
Set the end point (a filled square mark) of the rectangle.
Move the end point by tilting the ENTER key and press it to determine the position.
6.
Set the angle of the area.
Set the angle combining the following methods.
- ENTER key: Up/Down = Rotates by 1 degree.
- SHIFT key + ENTER key = Rotates by 0.01 degree.
Press the ENTER key to determine the angle. Now, area setting is completed.
Circle/ Ellipse
To draw a circle, set a start point and an end point of the circumscribed rectangle of the circle.
1.
Select "Circle" or "Ellipse" from "Change Shape" menu.
2.
Select "Change".
Now you can draw an area.
3.
Move the area.
Tilt the ENTER key to move the area.
Tilt the ENTER key pressing the SHIFT key to move the area by 10-pixel. (You
can use the SHIFT key also in setting of a start/end point.)
After moving is completed, press the ENTER key.
4.
Set the start point (a square mark).
Move the start point by tilting the ENTER key and press it to determine the
position.
5.
Set the end point (a filled square mark).
Move the end point by tilting the ENTER key and press it to determine the
position.
Now you completed drawing a circle.
6.
Set the angle of the ellipse.
Set the angle combining the following methods.
- ENTER key: Up/Down = Rotates by 1 degree.
- SHIFT key + ENTER key = Rotates by 0.01 degree.
Press the ENTER key to determine the angle. Now, ellipse area setting is
completed.
48