Panasonic PV500 User Manual page 409

Setting Invalid/Valid of Keypad operation
This is a command for prohibiting/permitting keypad operation in RUN MENU.
When keypad operation has been set to "Invalid", the keypad cannot be used. A message "Keypad is invalid" is
shown in the key guide space on the window. Even when setting to "Invalid", key emulate commands can be
received.
Send % B S ?
Receive % B S
Error (ERROR 1 signal = ON)
% B S
Error Code
270
271
Reading Keypad Operation Status
Send % B C
Receive % B C $
Canceling Inspection/ Processing (Cancel specific
operation)
Cancels the following active operations, and restores into the previous status before the operation.
·
Cancellation of the operation of a serial command which has been received
·
Abort of the status waiting for Individual trigger input
·
Abort of output in the status waiting for result output after an inspection is complete
·
Abort of image saving from Image Memory to a SD memory card
·
Cancellation of template re-registration
% C C
Send
Receive % C C $
Layout Switch
% I
Send
Receive % I
Error (ERROR 1 signal = ON)
% I
Error code
200
245
246
BCC CR ? = 0-1 (0 = Valid. 1 = Invalid)
$ BCC(10) CR
! Error code (3-digit)
Not available because SETUP MENU is displayed.
Other number than 0.1 and 1 is specified.
BCC CR
? BCC CR
BCC CR
BCC(01) CR
? ? BCC CR
$ BCC(48) CR
! Error code (3-digit)
Operation is stopped
• Although PV500 is operating (RUN), displaying SETUP menu cannot
switch layout.
• Other number than 00-31 is specified for layout number.
• No layout has been registered in the specified layout number.
BCC CR
BCC = 24 or **
? = 0-1 (0 = Valid. 1 = Invalid)
BCC = 25 or **
?? = 00 – 31 (Layout No.)
BCC CR
407