Panasonic PV500 User Manual page 400

Inspection start
When using common trigger in "Execute All" or "Automatic
Switch" execution mode
% S
Send
Receive % S
Error (ERROR 0 signal = ON)
% S
Error code
160
200
201
202
203
When using common trigger in "User-Defined" execution
mode
% S ?
Send
Receive % S
Error (ERROR 0 signal = ON)
% S
Error code
160
200
201
202
203
Example: Starts the inspection of block No.2.
Send
Receive
398
BCC CR
$ BCC(52) CR
! Error code (3-digit)
Position adjustment for a detect trigger is unset or a base position is unset
when "Camera Trigger" is set to "Detect Trigger (common)".
Operation is stopped.
"Camera Trigger" in "Camera" is set to "Individual".
Execution mode is "User-Defined".
No camera is connected.
BCC CR
$ BCC(52) CR
! Error code (3-digit)
Position adjustment for a detect trigger is unset or a base position is unset
when "Camera Trigger" is set to "Detect Trigger (common)".
Operation is stopped
• Execution mode is NOT "User-Defined" in PV500.
• "Camera Trigger" in "Camera" is set to "Individual".
The specified block is invalid (the number which does not/ cannot exist was
specified)
• No camera is connected.
• The specified camera number is set to "Unused" in PV500.
% S 2 * * CR
% S $ 5 2 CR
BCC = 76 or **
BCC CR
? = 0 - 9 (Block No. to execute)
BCC CR