Panasonic PV500 User Manual page 379

Cause
When switching layout;
• Although PV500 is operating (RUN), displaying SETUP
menu cannot switch layout.
• Other number than 00-31 is specified for layout number.
• No layout has been registered in the specified layout
number.
When sending parameter write command (%PW, %PWP);
• Because PV500 shows SETUP menu, parameters
cannot be written.
• Specification of the parameter is wrong.
(e.g. Undefined parameter is specified.)
• The specified parameter does not exist. (e.g. The
number of uncreated checker is specified as a
parameter.)
• The specified parameter value is out of the settable
range. (e.g. Maximum value of slice level is being set to
over 256.)
• The specified values led to the status of "Maximum
value < Minimum value" when entering them.
• When specifying the moving distance of the marker, a
part of the circumscribing rectangle of the marker (the
intersection point when Shape is Cross line) after
move was out of the nine screens where checker area
is settable.
• When the number of write commande received by
PV500 exceeds the receivable number when
executing one inspection.
When outputting the latest inspection image to a SD memory card or Ethernet interface(Output Latest Image);
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
• Output Condition* of Image Output is not set to
[Command Reception].
*"ENVIRONMENT" > "Input/Output" > "Image Output" >
"Output Conditions"
• There is no image captured.
When saving Image memory of PV500 in a SD memory card;
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
When saving Image memory of PV500 in a SD memory card,
there is no blank folder. (All of 00-99 are used.)
• No image is saved in the image memory.
When saving Print screen in a SD memory card or a PC through Ethernet;
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
• Ethernet communication cannot be established (with
connection problems such as cable unconnected or
disconnection).
• Image Receiver is not activated.
When sending the command prohibiting/permitting keypad operation
• The command was sent in SETUP MENU.
• Specification of the parameter is wrong. Other number
than 0 and 1 is specified.
Error
Solution, etc
Code
E0245 Switch to RUN menu,
E0246 Specify a correct layout number.
E0250 Switch to RUN menu.
E0251 Specify correct parameters.
E0252
E0253 Decrease commands to send to
PV500.
E0255 Correctly attach a SD memory
card which is writable and has
enough free space.
E0256 Set Output Condition to
[Command Reception].
E0257 Capture an image.
E0260 Correctly attach a SD memory
card which is writable and has
enough free space.
Delete all or some folders of 00 -
99 in the "Backup" folder of the
SD memory card.
E0265 Correctly attach a SD memory
card which is writable and has
enough free space.
E0266 Correctly connect Ethernet.
Activate Image Receiver, and set
it to "CONN: Standby".
E0270 Switch to RUN menu.
E0271 Specify correct parameters.
377