Table of Contents
Advertisement
Setting Measurement Condition
Measurement conditions vary depending on the type of geometry calculation.
Detect mode
Distance Point-Point
Intersecting Point
Median of Two Lines
Distance Point-Line
Approximate Line
Approximate Circle
Approximate Ellipse
About Measurement Conditions
Line Display
Select the display method of the detected line.
The following figures show the examples of "Distance Point-Point". The large circle is the start point (Reference
No. 0) and the small circle is the end point (Reference No. 1).
Segment
Draw between No.0 and
No.1
Angle Range
Specify 0 to 360 degree or -180 to 180 degree to output the angle data to be detected.
The position at three o'clock is 0 degree.
0 <-> 360
Measurement
condition
Line Display:
Segment / Half line0 / Half line1 / Wall-to-wall
Angle Range:
0<->360 / -180<->180
Direction:
ST -> ED / ED -> ST / Down / Left / Up / Right
Intersecting Angle:
Acute Angle / CW / CCW
Angle Range:
0<->360 / -180<-> 180
Direction:
Vector Sum / Down / Left / Up / Right
Intersecting Angle:
Acute Angle / CW / CCW
Line Display:
Segment / Half line0 / Half line1 / Wall-to-wall
Angle Range:
0<->360 / -180<-> 180
Direction:
OT0 -> IP / IP -> PT0 / Down / Left / Up / Right
Angle Range:
0<->360 / -180<-> 180
Direction:
Down / Left / Up / Right
None
Angle Range:
0<->360 / -180<-> 180
Direction:
Down / Left / Up / Right
Half line 0
Draw between No.0 and
the edge of the screen
-180 <-> 180
Half line 1
Draw between No.1 and
the edge of the screen
Wall-to-wall
Draw between the both
edges of the screen
217
- Quick Links:
- Pv500
Hide quick links:
Advertisement
Table of Contents
