Panasonic PV500 User Manual page 218

List of Settable Items for Each Object
PAC: Position Adjustment
AUC: Area Size
Adjustment
BEC: Binary Edge
GEC: Gray Edge
FEC: Feature Extraction
SMC: Smart Matching
FWC: Flaw Detection
CGE: Connector (Gray
Edge)
SEC: Smart Edge (Circle)
SEL: Smart Edge (Line)
GGC: Geometry
Calculation
*a) When selecting "Gap", "Float" or "Width Measurement" in Execution Mode
*b) When selecting "Measure Width" in Detect Mode
*c) When selecting "Measure Width" or "Measure Diameter" in Detect Mode
*d) Available only for the geometry calculations of the smaller numbers than the currently setting geometry
calculation
*e) Normally operation can be performed only with the following types which calculate line elements (abc):
Distance Point - Point / Median of Tow Lines / Distance Point - Line / Approximate Line
The checker with a camera number different from that selected for the setting geometry calculation cannot be
specified.
216
Point
○
Base Position Coord.
Detect Position Coord.
Base Coord. (Detect
Coord. of Base
Checker)
○
○
○
○
Center of Gravity
Coord.
Circumscribing
Rectangle Coord.
(Upper left, Upper right,
Lower left, Lower right)
○
○
○
Area 0
Area 1 (*a
○
Center Coord. 0
Center Coord. 1 (*b
Cell Individual Result 0
Cell Individual Result 1
(*c
○
Max. Measurement
Coord.
Min. Measurement
Coord.
Line0 Start Coord.
Line0 End Coord.
Line1 Start Coord. (*b
Line1 End Coord. (*b
Cell Individual Result 0
Cell Individual Result 1
(*b
○ (*d
All Points
×
×
○
○
○
(Center of Gravity
Coord.)
○
○
○
○
Cell Individual Result
0
Cell Individual Result
1 (*c
○
Cell Individual Result Line0 Element
0 Line1 Element (*b
Cell Individual Result
1 (*b
×
Line
×
×
×
×
×
×
×
×
×
○
○ (*d (*e