Panasonic PV500 User Manual page 267

5.
Set "Display Base".
Select from nine points (the encircled positions in the right figure), which
are eight points on the circumscribing rectangle of the characters
(including margins) and the center point.
Top Left (Default) / Top Center / Top Right / Left Center / Center / Right
Center / Bottom Left / Bottom Center / Bottom Right
When the displayed characters are numerical values, the size of the
circumscribing rectangle of characters depends on the "Digit Count"
optionally set.
6.
Set "Offset Unit", "Offset X" and "Offset Y".
The settable offsets X and Y are as shown in the
right table.
Optional Settings for Display Method
The following options are available depending on created display characters. Set as necessary.
Judge Display: "1/0/E" (Default) / "OK/NG/ER"
When Display Character is Judgement, select either values or
characters to display the judgement.
Digit Count: 1 to 15
Set when Display Character is numerical values.
Specify the digit number that is over the displayed values.
Set the total digit number including the symbol for negative values,
decimal point for actual values and the number of decimal places.
When the digit number of the displayed value exceeds the specified digit
count, all the digits are displayed as asterisks "*".
Decimal Digit: 0 to 3
Set when Display Character is actual values.
When the specified digit number is smaller than the number of decimal
places for the displayed value, the value is rounded to the specified digit
number.
Example) When Display Character is 100.125 and Decimal Digit is 2, the
displayed value is "100.13".
Alignment: Left (Default) / Center / Right
Set when Display Character is numerical values.
Select the alignment of characters when the displayed characters are
smaller than the specified digit count.
Offset Unit Offset X
±145
Character (Default)
±1600
Pixel
Offset Y
±54
±1200
265