Sony DVS-9000 User Manual page 119

An install key must be entered to use the software (see page 283).
To set light source data
The following example shows how to set light source data with the Light 1
menu.
If you use multiple light sources, use the same procedure for all light sources.
1
2
3
4
5
118
DME Special Effect Operations
In the <Spot Lighting Adjust> group of the Spot Lighting menu, press
[Light 1].
The Light 1 menu appears.
Press [Light 1], turning it on.
This enables the Light 1 light source, and you can now use the knobs to
adjust the parameters.
Set the following parameters.
Knob Parameter Adjustment
1 Total Brightness of whole image
Ambient
2 Intensity Intensity (brightness) of the light
source
3 Soft Softness of the lighted area
• Lowering the brightness of the image makes Spotlighting more
effective.
• The Total Ambient setting is shared with the Lighting function.
In the <Spot Mode> group, select the type of light source.
Parallel: Parallel light source. The direction can be set.
Point: Point light source. The position can be set.
Line: Line light source. The position and angle can be set.
Whole: Non-directional light source which illuminates the whole image
(no settings).
For more information about light source types, see "Digital Multi Effects
(DME)" in Chapter 1 (Volume 1).
According to the selected light source type, set the following parameters.
When you selected Parallel
Knob Parameter Adjustment
1 Longitude Longitude
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
Setting values
a)
–8.00 to +8.00