Parallel Output Settings (Output Config Menu) - Sony DVS-9000 User Manual

5
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
3

Parallel Output Settings (Output Config Menu)

For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally >Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU >Output
Config menu.
404
Setup Relating to DCU
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising edge the
set AUX bus primary input is used. On a falling edge, the original state of the cross-
point is restored. If the GPI trigger is applied repeatedly at short intervals (0.5
second or less), the cross-point switching may not be carried out correctly. In this
case, apply the GPI trigger again.
b) When knob 2 selection is "Key Snapshot"
c) When knob 2 selection is "Snapshot"
d) When knob 2 selection is "Effect"
e) When knob 2 selection is "Aux ? O'ride Src ??"
To confirm the setting in step 4, press [Action Set].
This confirms the setting, which appears in the status area.
In the DCU >GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
1 No
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Adjustment
Signal format/screen aspect ratio
selection
Setting values
1 and upwards