Sony DVS-9000 User Manual page 385

To display the Device Interface menu
In the Engineering Setup menu, select VF3 'Switcher' and HF7 'Device
Interface.'
Making 9-pin port device interface settings
The description in this section takes the REMOTE3 port as an example. For
other REMOTE ports, carry out the same process as required.
1
2
Note
When REMOTE3 and REMOTE4 are respectively assigned to DME1 and
DME2, you can switch the AUX bus from the DME (DME-3000/7000)
connected to these ports.
At this time, connect the DME input video signals and key signals as follows.
• DME1 video input: AUX1 output
• DME1 key input: AUX2 output
• DME2 video input: AUX4 output
• DME2 key input: AUX5 output
Note that for a DME external video signal, you can select any of AUX1 to
AUX14 on the DME. Connect to the selected AUX bus.
Making switcher processor GPI input settings
1
2
384
Setup Relating to Switcher Processor
In the Switcher >Device Interface menu, press [Remote Assign].
The Remote Assign menu appears.
Select the device interface you want to set for the REMOTE3 port from the
<Remote3> group.
Editor A: assign Editor A to the REMOTE3 port.
Editor B: assign Editor B to the REMOTE3 port.
AUX: assign AUX to the REMOTE3 port.
DME1: assign DME1 to the REMOTE3 port.
In the Switcher >Device Interface menu, press [GPI Input].
The GPI Input menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Port Port selection
Setting values
1 to 8